![]() Not sure if there is something with the fw’s drivers thats causing this. ![]() The only difference with me is that I do not use the audio from my tascam. Everything you are saying that you’re doing is exactly what I would have asked you to check. ![]() I have the FW-1884 with 2 FE 8 extenders and it works find except for a faulty fader in one of my fe-8’s. And there are no audio levels in Cubase or on the FW-1884 during playback. Same results: Cubase can control the FW-1884, but not the other way around. Tried adjusting the faders on the FW-1884 – no response in Cubase. I added Mackie Control under Remote Devices and set the MIDI input and output to FW1884 Control.Īdjusted the faders in Cubase – the faders on the FW-1884 responded in kind. The FW-1884 is configured to Mackie Control Emulation. Played the song – no audio levels in Cubase or on the FW-1884. Set the VST Connections for stereo output to channels 1 and 2. ![]() Powered on the fw-1884 – now the firewire light on the fw-1884 lights up. changed the 1394 driver to the legacy driver and rebooted. UTILIZATION Trs simple to use, driver install. Connected the new firewire cable from the expansion card to the fw-1884. Of 24-bit 96 khz, control surface, midi and audio interface for audio recording 18 tracks simultaneously, gnial. Installed the pci firewire card with the TI chipset. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |